Franklin’s 8-inch Submersible Motors

 

Franklin’s 8-inch submersible motors are typically used in large demanding water wells requiring high flow rates or deeper installations. These motors are tough, built to last, and come in a variety of construction options.
Condition New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller’s listing for full details.
Brand: Franklin Electric
Type: Submersible, Sump
Country/Region of Manufacture: United States

Ratings

HP: 200 hp
Frequency: 50/60 Hz
Phases: Three-Phase
Amps – Full Load: 246 A
Amps – Service Factor: 282 A
Volts: 380 VAC / 460 VAC
Voltage Tolerance (%): -10.0% / +10.0%
Wire: 3-Wire
Motor Connection: DOL
Thrust Bearing Rating: 10000 lb
Lead Length: 13 ft
Motor: Encapsulated
Continuous Duty: Yes
Efficiency Service Factor Load [%]: 88.00 %
Protection [IP]: IP68
Lead Wire Size: AWG #2
Motor Insulation Classification: F
Poles: 2
S.F.: 1.15
Motor Cooling: Water
Minimum Cooling Flow: .50 ft/sec
Motor Ambient Temperature Rating Nominal: 86 °F
Thrust Bearing Rating: 10000 lb
Motor Adapter: Double flange
Rotation: Counter clockwise facing the shaft
SubTrol Heat Sensor YES: Yes

Materials of Construction

Motor Shaft End – Material: 17-4SS
Thrust Bearing: Kingsbury
Seal Mechanical Seal: SiC/SiC
Lead Insulation Material: XLPE
Diaphragm Material: Nitrile Rubber (NBR)
Motor Bottom End Bell Material: Cast Iron with E-Coat Paint
Motor Fill Solution (Water Soluble / Non Toxic): YES
Motor Fill Solution: FES91
Motor Top End Bell Material: Cast Iron with E-Coat Paint
Shaft Slinger Material: No
Stator Ends Material: Carbon Steel
Stator Fill: Resin
Stator/ Motor Shell Material: 300 Series SS
Winding Material: Copper

Dimensions

Motor Diameter – Physical Diameter: 7.70″
Motor Length: 94.8 ”
Product Weight: 925 lb
Product Weight with Pack: 1040 lb
Carton Length: 108 ”
Carton Width: 9 ”
Carton Height: 17 ”
Shaft Diameter: 1.5 ”
Shaft End: Spline

Other

Drinking Water Agency Approvals: ANSI/NSF Standard 61
Electrical Agency Approvals: UL
Warranty Standard Time: 12 Mo. from Date of Install / 24 Mo. from Date of Manufacturing

Disclaimer: Product images are for representation purposes only. Actual part/product could differ based on individual requirements. Please contact us for more information.

Brand

Alcohol, Bourboh, Cocktail bar, Cocktails, Glenfiddich, Patron, Vodka, Wineclub, ABB, AMI Bearings, Baldor, Bijur Delimom, Elite Safety, Exim Engg, Farval, Hillbrush, Invertek, PowerTwist

Horsepower

1

Input Voltage

500-600V 3 Phase

size

L, M, S, XL, XS, XXL, 1, 2, 3, Frame 1, Frame 2, Frame 3

Shopping Cart